Switch(config)# interface gi1 Switch(config-if)# power inline auto time-range workhour Use the following command to verify your configuration. auto—Turns on the device discovery protocol and applies power to the device. NAME—Specify the name of time-range settings. When the time range is not in effect the power is. Displays the port power status: Lists all PoE-capable ports on the switch. Shows Yes for ports enabled to support PoE (the default) and No for ports on which PoE is disabled. (For more information on this topic. Detection In Progress —Detection of the powered device is ongoing. Show interface status: This command will provide information about the status of each interface, including whether PoE is enabled. To check the Power over Ethernet (PoE) status on a Cisco switch, you can use several commands in the command-line interface (CLI).
